 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2014, 10:16
|
Boundary conditions for a phase in fluent
|
#1 |
|
New Member
arrmando
Join Date: May 2014
Posts: 16
Rep Power: 12  |
Hi guys,
I am running a VOF simulation with 3 different fluids. What I need is to set 3 different outlet boundary conditions. My problem is that when I try to select the boundary condition type (for a specific phase) only "wall" is available. For me to be able to select outlet I must change the phase to "mixture". Why is this the case? How can I make an outlet boundary condition just for a certain phase and not all? Best Regards, AA |
|
|
|
|
 |
| Tags |
| ansys, boundary conditions, fluent, vof |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 07:18 |
| Boundary conditions in Fluent 4.5 | Arturo Ortiz | FLUENT | 0 | January 25, 2001 18:52 |
Linear Mode
