How to solve in ANSYS V12.1 model information problem.

Ilker · March 22, 2014, 18:36

Hi all,

I drew in ANSYS V12.1 a simple geometry. I completed drawing and then I made the mesh. While I was making the mesh I created five different regions (boundaries) and named these regions respectively. I completed making the mesh and then while I opened the "Setup" section I met "The model information is not compatible with the mesh" failure. I attached the the file to clearify and to identify the problew which I met when I opened the Setup section in ANSYS V12.1.

Does anybody has any information to solve "the model information is not compatible with the mesh" problem? I will be very pleasure for your helps.

Thanks for your attention and for your helps.

Ilker · March 22, 2014, 21:32

I have investigated for a long time to solve this problem. If anybody has any idea how to solve or fix this proble would anybody like to share?

Thanks a lot for your attention.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pro/E to ANSYS Parameterization Guide	Trues	ANSYS	4	April 18, 2018 06:52
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
How to use non-equilibrium thermal model for porous medium in Ansys CFX 13.0?	Chander	CFX	3	November 28, 2011 15:26
Problem in Buoyancy Model?	dhrubo	CFX	3	June 5, 2010 06:32
extremely simple problem... can you solve it properly?	Mikhail	Main CFD Forum	40	September 9, 1999 10:11

March 22, 2014, 21:32		#2
Ilker New Member Join Date: Jan 2013 Posts: 6 Rep Power: 13	I have investigated for a long time to solve this problem. If anybody has any idea how to solve or fix this proble would anybody like to share? Thanks a lot for your attention.