|
[Sponsors] |
May 28, 2012, 05:02 |
Piston Meshing Quality Problems
|
#1 |
New Member
Anniruddha
Join Date: May 2012
Posts: 4
Rep Power: 14 |
I am trying to mesh a piston geometry in 3D. I want to achieve surface mesh quality of 0.4 ani tetra mesh quality of 0.3. are there any alternatives rather than using Robust Octree method to achieve the required quality?
Please help me as I am doing it on my own and i have tried many thing but not getting the correct results. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh quality problems: maximum skewness larger than 0.98 | cth_yao | FLUENT | 4 | May 19, 2016 11:59 |
[ICEM] Wind turbine meshing problems in ICEM | luxingzhe | ANSYS Meshing & Geometry | 0 | November 28, 2011 06:55 |
Meshing problems using Gambit | Vianney | FLUENT | 4 | May 30, 2009 04:45 |
Problems in Meshing Cyclone | Sal | FLUENT | 3 | September 19, 2007 11:21 |
FloWizard - problems in meshing | Mark | FLUENT | 0 | June 21, 2006 06:55 |