Changes to named selections not appearing in CFX?

steady-state · May 13, 2012, 21:28

Can anyone suggest why CFX Pre does not always pick up changes in Named Selections that I make in the ANSYS Mechanical Meshing?

Often I'll add or subtract geometry from a named selection or create a new one, hit update, and refresh CFX Pre, but can't see the new named selection in CFX Pre? Any thoughts as to why this is happening?

rockzh · June 27, 2012, 21:35

I have the same problem,
do you get the answer?
thank you

Darren Leong · July 18, 2012, 03:00

Tools>Options>Geometry Import>

Check that Named Selections is enabled (tick left box) and delete the filtering prefixes which usually 'NS' by default.

The setting above applies to new projects created after the change tho.

l.whelan11 · January 29, 2017, 13:29

Had the exact same problem, added a named selection in the mesh but could never get it to update in the setup. For me, it was solved by doing the following:

File -> Recorded Mesh Options -> Match Zone Names

Had to close the solver and open it again to get the new named selection to show up but it seemed to work after that. Don't know why this is the solution, not very intuitive (to me at least).

May 13, 2012, 21:28	Changes to named selections not appearing in CFX?	#1
steady-state New Member Scott Join Date: Mar 2012 Posts: 9 Rep Power: 14	Can anyone suggest why CFX Pre does not always pick up changes in Named Selections that I make in the ANSYS Mechanical Meshing? Often I'll add or subtract geometry from a named selection or create a new one, hit update, and refresh CFX Pre, but can't see the new named selection in CFX Pre? Any thoughts as to why this is happening?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error in recompiling the solver	m.maneshi	OpenFOAM Running, Solving & CFD	0	August 28, 2010 15:14
CFX pressure in Simulations problem	nasdak	CFX	1	April 14, 2010 14:22
PhD using CFX	Rui	CFX	9	May 28, 2007 06:59
CFX 10 VS CFX 11 for combustion	Jonathan Lemay	CFX	2	May 9, 2007 12:58
FSI using CFX and ANSYS	Bi Chang	CFX	2	May 10, 2005 05:47

June 27, 2012, 21:35		#2
rockzh New Member Darren Zhang Join Date: Nov 2011 Location: China Posts: 20 Rep Power: 15	I have the same problem, do you get the answer? thank you

July 18, 2012, 03:00		#3
Darren Leong Member Darren Leong Join Date: Dec 2010 Posts: 64 Rep Power: 16	Tools>Options>Geometry Import> Check that Named Selections is enabled (tick left box) and delete the filtering prefixes which usually 'NS' by default. The setting above applies to new projects created after the change tho.

January 29, 2017, 13:29		#4
l.whelan11 New Member Luke Whelan Join Date: Jan 2017 Posts: 9 Rep Power: 9	Had the exact same problem, added a named selection in the mesh but could never get it to update in the setup. For me, it was solved by doing the following: File -> Recorded Mesh Options -> Match Zone Names Had to close the solver and open it again to get the new named selection to show up but it seemed to work after that. Don't know why this is the solution, not very intuitive (to me at least).