 |
 |
 |
|
|
|
[Sponsors] | ||||
April 5, 2012, 02:55
|
Bias
|
#1 |
|
New Member
Cameron
Join Date: Mar 2012
Posts: 1
Rep Power: 0  |
Hi,
I am fairly new to ANSYS and have a question about meshing. I am modelling a self buried pipeline and need to have an initial cell size of around 0.001 (near the seabed). I can get this with bias using 80 divisions and a bias factor of 800. My domain is 10D in y direction (height) and 40D in x direction with the pipe sitting at 20D (half way along). I have attached some pictures of my geometry. Help would be greatly appreciated. Cam |
|
|
|
|
 |
| Tags |
| bias, bias factor, divisions, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] edge sizing control--Calculate cell-to-cell expansion rate from bias factor | la7low | ANSYS Meshing & Geometry | 6 | December 19, 2021 07:49 |
| [ANSYS Meshing] Bias and Bias Factor | Hybrid | ANSYS Meshing & Geometry | 7 | April 19, 2017 00:56 |
| bias mesh | kbasnet | ANSYS Meshing & Geometry | 1 | March 2, 2011 21:52 |
Linear Mode
