[ICEM] Using Blocking with ICEM (infinite blocking lines appeared)

Touré · November 7, 2011, 19:58

Hello,
I am trying to mesh with ICEM a rectangular domain of a flow over a plate using 2D Planar Blocking (Figure3) method. When I use Blocking my 2D domain is not closed. The upper and lower blocking lines continue on the right and left sides to infinity ???
The simple geometry is below. I think that it is an environment setting (Picture 2) problem but I don't know which one. In picture5, VORFN is activated.
Any suggestions.

Touré · August 5, 2012, 18:08

It was the tolerance which were too big. I reduced the tolerances in Menu -> Settings -> Model

Far · August 5, 2012, 18:27

This may be caused due to some entity placed at some large distance from the main object.

August 5, 2012, 18:08	Solved	#2
Touré Member Guiliguili Join Date: Aug 2010 Location: Montréal Posts: 97 Rep Power: 16	It was the tolerance which were too big. I reduced the tolerances in Menu -> Settings -> Model

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Using Blocking with ICEM (infinity lines appear)	Touré	ANSYS Meshing & Geometry	6	August 5, 2012 18:07
No Blocking tab in Ansys ICEM CFD11.0	NewGuy	CFX	1	November 22, 2010 16:38
Ansys ICEM 12.0 Searching for tutorial information on complex 3d blocking	Raoul	ANSYS	1	October 18, 2010 07:08
ICEM blocking	Chris Wetton	CFX	6	March 9, 2008 06:18
ICEM Blocking 2D and Fluent error	Dr. Flow Squad	FLUENT	3	March 5, 2007 03:27

August 5, 2012, 18:27		#3
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	This may be caused due to some entity placed at some large distance from the main object.