 |
 |
 |
|
|
|
[Sponsors] | ||||
October 15, 2011, 22:53
|
Ansys Design Modeler complex geometry
|
#1 |
|
Member
Nathan
Join Date: Aug 2010
Posts: 62
Rep Power: 16  |
Hi
I have a complex agglomoration of particles in the design modeler, this agglomoration is bounded by a box. How can I make design modeler recognize the pore space. That means subtracting a complex geometry from a full box which gives acomples pore network. Can anyone tell me the exact procedure? Thank You, |
|
|
|
|
|
October 17, 2011, 09:57
|
|
#2 |
|
Senior Member
Julio Mendez
Join Date: Apr 2009
Location: Fairburn, GA. USA
Posts: 290
Rep Power: 18  |
I think you should use a porous media.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Design Modeler imported geometry | natantyt | ANSYS Meshing & Geometry | 0 | June 11, 2011 20:44 |
| Problem exporting line bodies form Design Modeler to Mesh Editor&Fluent | Rockda | ANSYS Meshing & Geometry | 0 | May 26, 2011 12:03 |
| Need some basic information for using Ansys Design Modeler | pradeepmash | ANSYS Meshing & Geometry | 3 | October 24, 2010 17:01 |
| [Other] ANSYS Design Modeler | OxIan | ANSYS Meshing & Geometry | 0 | August 4, 2010 14:13 |
| 2-D Design Modeler Geometry - Ansys 12.0 | hodeje01 | ANSYS Meshing & Geometry | 2 | October 7, 2009 11:42 |
Linear Mode
