 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Internal gear pump mesh deformation CFX V11 |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 22, 2011, 11:22
|
Internal gear pump mesh deformation CFX V11
|
#1 |
|
New Member
Malik
Join Date: Jun 2011
Location: Paris
Posts: 2
Rep Power: 0  |
Hello Dear colleagues,
I hope someone can give me some advice. I'm trying to simulate an internal gear pump. My problems it 's about the strategy in order to mesh the geometry and the mesh deformation. A junction box routine is enough to generate the mesh deformation? I have lot of hesitations about the nodes displacement requirements.  Thank youuuuuuuu 
Last edited by Malik77; August 22, 2011 at 11:48. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
| Mesh Adaption in CFX. | Kushagra Mittal | CFX | 1 | August 31, 2011 09:17 |
| A question on adaptive remeshing or mesh deformation for handling object motions | daveatstyacht | OpenFOAM | 10 | November 13, 2010 10:29 |
| CFX mesh deformation | YY | CFX | 0 | May 3, 2008 19:52 |
| CFX mesh & ICEM | mike | CFX | 3 | April 27, 2006 16:27 |
Linear Mode
