 |
 |
 |
|
|
|
[Sponsors] | ||||
May 2, 2011, 08:25
|
How to block this geometry?
|
#1 |
|
New Member
Join Date: Apr 2011
Posts: 12
Rep Power: 15  |
Hey guys,
I really need help blocking this inlet. The fluid (air) enters the part from the back. I'm not sure how to block this geometry to get a proper result. It would be nice if you could tell me how to cut the blocks. Thanks in advance! |
|
|
|
|
|
May 2, 2011, 08:49
|
|
#2 |
|
Member
Lorenzo Mazzei
Join Date: Dec 2010
Posts: 60
Rep Power: 15 |
two blocks could be sufficient in my humble opinion.
|
|
|
|
|
|
|
May 3, 2011, 04:07
|
|
#3 | |
|
New Member
Join Date: Apr 2011
Posts: 12
Rep Power: 15 |
Quote:
I still have another problem with that kind of blocking: the face between the orange and the yellow line always gets associated to the following geometry/blocks with follow this part of geometry. I dont seem to be able to handle that. |
||
|
|
|
||
|
May 3, 2011, 04:37
|
|
#4 |
|
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 18 |
you can disassociate that face if you wanted to do so by going to - Blocking --> Edit associations --> Disassociate from geometry and then select the faces to disassociate
__________________
Best regards, Santhosh. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] O-grid around wing geometry | Anorky | ANSYS Meshing & Geometry | 15 | November 27, 2017 14:43 |
| [Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 03:58 |
| Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 09:17 |
| vitual _ real | deneb | FLUENT | 3 | January 22, 2007 05:31 |
| block geometry inside fluid domain | jeff | Main CFD Forum | 18 | April 12, 2004 12:37 |
Linear Mode
