 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2011, 21:21
|
meshing quality for CFX
|
#1 |
|
Member
iswadi
Join Date: Feb 2010
Posts: 44
Rep Power: 16  |
hi,
i`m a newbie in Ansys Meshing. i have gone through some tutorials and training materials on Ansys meshing and CFX. It has mentioned in the training materials about the determination of mesh quality in CFX. however this determination can only be notice in CFX solver manager. The CFX solver manager will show us whether the meshing is OK (good), ok (acceptable) or ! (bad). i think it takes me too long procedure just to know either my mesh is good or bad. Are there any guidance in determining the meshing quality criteria for CFX in Ansys workbench meshing? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Hex meshing producing poor quality elements on multibody part | aarvay | ANSYS Meshing & Geometry | 8 | March 16, 2012 16:29 |
| ANSYS Meshing - DC Mesh Quality | alven299 | ANSYS Meshing & Geometry | 5 | July 19, 2010 12:34 |
| [ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 04:25 |
| [GAMBIT] how to managing quality type of meshing?? | teguhtf | ANSYS Meshing & Geometry | 0 | December 22, 2009 19:51 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Linear Mode
