 |
 |
 |
|
|
|
[Sponsors] | ||||
April 20, 2011, 09:07
|
Mesh Boundary Layer
|
#1 |
|
New Member
steve levitt
Join Date: Jun 2010
Location: UK
Posts: 9
Rep Power: 16  |
I am trying to mesh a wing using the Multizone mesh for the first time.
How do I mesh the boundary layer that was formally done in CFX mesh using the inflation layer. Does inflation also work in Multizone or can I control the height of the mesh in the surface region separate from the mesh size? Steve |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 09:07 |
| How to make boundary layer mesh moving with wall | wayne | FLUENT | 3 | June 12, 2008 00:23 |
| Is the boundary layer suitable for dynamic mesh? | Lien | FLUENT | 0 | December 26, 2007 02:41 |
| AMG divergence and boundary layer mesh | Justin | FLUENT | 0 | November 4, 2007 18:24 |
Linear Mode
