 |
 |
 |
|
|
|
[Sponsors] | ||||
March 17, 2011, 11:56
|
Hexa core - Error
|
#1 |
|
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 18  |
An error was encountered when I tried to generate a hexa core mesh out of an existing tet prism mesh. The details can be found in the word document attached to this post
Some one please go through it and suggest a solution , any help is greatly appreciated
__________________
Best regards, Santhosh. |
|
|
|
|
|
March 25, 2011, 18:59
|
Limitations...
|
#2 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
It doesn't like your mesh size in the volume... The ICEM CFD HexCore is limited by rules that require conformal mesh between the hexas and the tetras... If you have any hanging nodes their is a failure... If your mesh size (between the tetra and Hexas) is too far off, you get a failure...
__________________
----------------------------------------- Please help guide development at ANSYS by filling in these surveys Public ANSYS ICEM CFD Users Survey This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)... CFD Online Users Survey |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 08:43 |
| POSDAT problem | piotka | STAR-CD | 4 | June 12, 2009 09:43 |
| [Netgen] Installation of Netgen in SuSE Linux 92 | edvardsenpriv | OpenFOAM Meshing & Mesh Conversion | 23 | January 16, 2009 07:12 |
| How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 06:07 |
Linear Mode
