[ICEM] Nodes on sides of the edges don't match

Attesz · February 9, 2011, 09:25

Hi ICEM users,

i've a problem related do 2D mapped hexa meshing. There is an edge, where the nodes don't match. There are no multiple edges on each other, I've checked it. The vertices, edges are well associated to points and curves. But the nodes as you see on the pic, don't match. Do you have any suggestion excluded the fully rebuild of the model?

Thank you in advance,

Attila

icem.jpg

PSYMN · February 10, 2011, 21:20

This doesn't seem right... A single edge can't have two distributions. Therefore that can't be a single edge.

Try a couple more things in the display tree to diagnose the problem.

Right click on Verticies and turn on "Numbers", this will make it easier to see overlaps because you will see overlapping numbers at the vertex.

Right click on Edges and turn on color by count. edges that connect two blocks should show up red. Yellow edges indicate a disconnect.

February 9, 2011, 09:25	Nodes on sides of the edges don't match	#1
Attesz Senior Member Attesz Join Date: Mar 2009 Location: Munich Posts: 368 Rep Power: 17	Hi ICEM users, i've a problem related do 2D mapped hexa meshing. There is an edge, where the nodes don't match. There are no multiple edges on each other, I've checked it. The vertices, edges are well associated to points and curves. But the nodes as you see on the pic, don't match. Do you have any suggestion excluded the fully rebuild of the model? Thank you in advance, Attila icem.jpg

February 10, 2011, 21:20	A single edge can't have 2 distributions.	#2
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	This doesn't seem right... A single edge can't have two distributions. Therefore that can't be a single edge. Try a couple more things in the display tree to diagnose the problem. Right click on Verticies and turn on "Numbers", this will make it easier to see overlaps because you will see overlapping numbers at the vertex. Right click on Edges and turn on color by count. edges that connect two blocks should show up red. Yellow edges indicate a disconnect.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 09:54
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 20:43
gmsh2ToFoam	sarajags_89	OpenFOAM	0	November 24, 2009 23:50
Displaying only edges and not nodes of the grid in contour views	val3312	FLUENT	1	May 26, 2009 03:27
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19