|
[Sponsors] |
December 1, 2010, 08:04 |
3D Cooper Meshing failure
|
#1 |
New Member
ritwik
Join Date: Nov 2010
Posts: 5
Rep Power: 16 |
Hello all,
I am working on a 3d problem which involves usage of Quad Map on the meshing of faces and two faces (which become the source faces in the Cooper meshing of volume) which are Quad Pave. I had run some dummy tests and found that Cooper usually works when the sides have similar style of meshing. Is there any way I can get the Cooper mesh to work for the volume? PLEASE Do suggest. Thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] Issues with Cooper Volume Meshing | Forrest | ANSYS Meshing & Geometry | 6 | September 19, 2018 05:07 |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 01:35 |
Meshing tank with two opposite inlet/outlet with cooper | TfG | FLUENT | 0 | April 20, 2009 10:03 |
Cooper meshing error: intersecting edge | Stuart | FLUENT | 5 | February 26, 2009 07:46 |
IMPRINT COMMAND IN COOPER MESHING SCHEME | TINA | FLUENT | 3 | October 7, 2006 06:03 |