 |
 |
 |
|
|
|
[Sponsors] | ||||
September 29, 2010, 16:53
|
Overlapping/ negative volumes
|
#1 |
|
New Member
Saikiran
Join Date: Sep 2010
Posts: 15
Rep Power: 16  |
Hi everyone....i have given mesh parameters for edges in the geometry but among 10 channels only one of it has negative volumes. Could someone point out the error. And kindly suggest some general procedures to be followed to remove such elements.
|
|
|
|
|
|
September 30, 2010, 04:37
|
|
#2 |
|
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 22 |
I don't know what is the best way to solve your issue, but I have noticed that it may come from the edge association or the edge parameters. So,
1) undo the edges association and redo it. If it doesn't work : 2) reset all your edge parameters, and redo it. If it doesn't work : 3) Redo your blocking 
|
|
|
|
|
|
|
October 1, 2010, 23:23
|
Minor blocking issue.
|
#3 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Please zoom in closer and take another pic... I can't see the problem from here.
Scan planes across the problem would also help you see what is going wrong. I don't think you need to redo the blocking  It is just a minor problem. You are almost done. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
| negative grid volumes when adapting | Dave | FLUENT | 1 | August 20, 2005 14:47 |
| Problem in identifying Negative volumes in Fluent | Senthil | FLUENT | 1 | April 19, 2003 11:16 |
| Gambit mesh & Negative Volumes | Ashutosh | FLUENT | 5 | February 21, 2001 01:59 |
Linear Mode
