 |
 |
 |
|
|
|
[Sponsors] | ||||
September 21, 2010, 17:27
|
STL file to IGES
|
#1 |
|
New Member
Sandeep
Join Date: Aug 2010
Posts: 7
Rep Power: 16  |
Hello Everyone,
I am trying to extract a IGES geometry file from a STL geometry in ICEM. Here is what I tried so far. 1. Imported STL geometry into ICEM 2. Extracted surfaces & curves from STL file. After this ICEM allows me to save *tin file. I used this *.tin file to export IGES geometry but for some reason it comes out as blank. It works fine for other *tin files given as examples/tutorials but doesn't work for STL files. Has anybody tried this before? Any help/ideas will be appreciated. Thanks Sandeep |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| STL File - Mesh Surface Problems | Harmeet | FLUENT | 8 | May 13, 2010 22:59 |
| Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory' | mfiandor | OpenFOAM Installation | 2 | January 25, 2010 10:50 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 02:24 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
Linear Mode
