 |
 |
 |
|
|
|
[Sponsors] | ||||
June 30, 2010, 17:33
|
exporting the modified mesh from ansys
|
#1 |
|
New Member
Join Date: Jun 2010
Posts: 1
Rep Power: 0  |
Hello,
I have a question regarding Ansys 12.1 and a mechanical simulation that has been run. I have a lot of experience with fluent but this workbench software is a whole new bag of worms. Currently I would like to export the structure that Ansys mechanical presents as results. I'm hoping to run a fluid simulation on the deformed structure, but when I export a mesh from ansys it just gives me the same mesh that I originally used. When presented with results ansys also exaggerates the results so that the problems in the structure are more identifiable. Is there is a way to export the modified structure that ansys presents as a mesh? Thanks ahead of time for all your help. |
|
|
|
|
|
September 5, 2013, 12:08
|
|
#2 |
|
New Member
No sorry
Join Date: Sep 2013
Posts: 1
Rep Power: 0 |
*** push ***
Same problem with the deformed mesh. I want to use the results of the static structural mechanical for my CFD simulation. Any ideas? *** push *** |
|
|
|
|
|
 |
| Tags |
| ansys, export, fluent, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
| prob while exporting icem cfd hexa mesh to fluent | mani | CFX | 4 | March 7, 2007 04:41 |
| 2D mesh by ANSYS Workbench 8.1 | Dome | CFX | 4 | June 6, 2005 07:20 |
Linear Mode
