How to mesh a swept wing in ICEM? -- CFD Online Discussion Forums

April 24, 2010, 13:34

How to mesh a swept wing in ICEM?

kepeng

New Member

Ke peng

Join Date: Jul 2009

Posts: 19

Rep Power: 17

Hi, every one.
I currently try to mesh a swept wing, with the airfoil of NACA65a008, where the trailing edge is just a line. firstly, i split it into a O-grid, then split it into 3 part along in spanwise. Finally i got a very bad quality mesh, especially near the wing tip and root, where is just triangle near the trailing edge.

could somebody give me some advise on how to mesh a swept wing? Thanks a lot.

the geom and mesh is attached.

Attached Images

	wing-geom.JPG (6.9 KB, 44 views)
	wing-mesh.JPG (83.4 KB, 57 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to open Icem mesh in Ansys Fluent?	emmkell	FLUENT	27	February 6, 2018 04:34
ICEM hexa mesh built with v10 deformed in v11 (degenerated edges)	cfxicem	ANSYS Meshing & Geometry	1	October 14, 2009 16:06
Boddy fitted Hexcore Mesh in ICEM Cfd	Mitch	CFX	0	December 29, 2008 07:07
How to corse mesh in icem cfd?	Priety	CFX	2	October 2, 2006 04:57
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 20:04

All times are GMT -4. The time now is 00:11.