|
[Sponsors] |
March 29, 2010, 15:48 |
2D Face Meshing Problem
|
#1 |
Member
Jack
Join Date: Mar 2010
Posts: 32
Rep Power: 16 |
Hi,
When I want to mesh a 2D surface, an error will appear and it does not mesh it in Quad/Submap scheme,but I can mesh it with pave/tri schemes. The error is "The number of intervals on the meshed face face.1 does not allow meshing with this scheme" Anybody has an idea?? Thanks. |
|
March 30, 2010, 02:01 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
Is your surface mappable? (does gambit choose automatically hex-mapp schema?)
a picture could be helpfull
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
April 8, 2010, 03:52 |
|
#3 |
Member
Jack
Join Date: Mar 2010
Posts: 32
Rep Power: 16 |
I figured it out. The problem was about some of my edge mesh. Thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Internal walls of zero thickness | anger | OpenFOAM Meshing & Mesh Conversion | 23 | February 6, 2020 19:25 |
[Commercial meshers] Face ordering problem for nonrectangular cyclic boundary conditions | cfdmarkus | OpenFOAM Meshing & Mesh Conversion | 3 | August 17, 2011 16:07 |
problem meshing in GAMBIT | khairul hadi | Main CFD Forum | 1 | August 20, 2008 18:13 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
Gambit meshing problem | David Banks | Main CFD Forum | 0 | July 19, 2007 12:48 |