workbench and control mesh with y+

zandi · January 17, 2010, 16:33

Hi
How I can control y+ in workbench as I do meshing?
I need it for CFX

PSYMN · January 20, 2010, 09:48

You don't mention a particular mesher...

I asked John Stokes@CFX about it and he sent me this chunk from the CFX-Mesh manual...

Best regards,

Simon

PSYMN · January 20, 2010, 09:49

So if you are using CFX-mesh, open up the help and look for Y+. You will find a section on it.

PSYMN · January 20, 2010, 09:51

Actually, you could use that simple equation manually if you like and enter the calculated first cell height into any mesher...

Sorry for the three posts instead of 1.

zandi · January 20, 2010, 13:35

sHello
realy appreciate your help and advice
I read your post recently so I will read it and come back
thankz again

January 17, 2010, 16:33	workbench and control mesh with y+	#1
zandi Senior Member Fatema Zandi Goharrizi Join Date: Mar 2009 Posts: 158 Rep Power: 17	Hi How I can control y+ in workbench as I do meshing? I need it for CFX

January 20, 2010, 09:49	Look it up in the manual.	#3
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	So if you are using CFX-mesh, open up the help and look for Y+. You will find a section on it.

January 20, 2010, 09:51	Last thought...	#4
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	Actually, you could use that simple equation manually if you like and enter the calculated first cell height into any mesher... Sorry for the three posts instead of 1.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Running same project in workbench 12 with duffrent speeds	sberez	CFX	3	October 20, 2009 08:31
mesh quality to CFX	thiagu	CFX	4	December 4, 2008 01:55
cfx time scale control	Kordou	CFX	2	September 22, 2008 12:07
ansys 11--icemcfd mesh or workbench mesh better	Nav	CFX	3	July 11, 2008 07:43
How to obtain the same volume of mesh	Dome	CFX	0	April 22, 2005 14:32

January 20, 2010, 13:35		#5
zandi Senior Member Fatema Zandi Goharrizi Join Date: Mar 2009 Posts: 158 Rep Power: 17	sHello realy appreciate your help and advice I read your post recently so I will read it and come back thankz again