 |
 |
 |
|
|
|
[Sponsors] | ||||
June 13, 2024, 06:56
|
Split edges problem
|
#1 |
|
New Member
Join Date: Jun 2024
Posts: 1
Rep Power: 0  |
Helllo,
when trying to split a line using the tool "split edges" the line is split inverted to what I want. Instead of getting the small area at the bottom, it is located at the top. How can I solve this? Thanks in advance. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 10:12 |
| [snappyHexMesh] snappyHexMesh does not work | Siassei | OpenFOAM Meshing & Mesh Conversion | 8 | September 28, 2023 05:01 |
| [Other] 2D adaptive Mesh Refinement | baco | OpenFOAM Community Contributions | 80 | August 14, 2022 15:18 |
| [ICEM] Multiple edges problem when merging hexa/tetra mesh | earth07 | ANSYS Meshing & Geometry | 3 | May 31, 2013 04:29 |
| [ICEM] Problem with the Split Face Option | saisanthoshm88 | ANSYS Meshing & Geometry | 3 | January 12, 2011 18:05 |
Linear Mode
