 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2024, 10:44
|
Meshing for complex geometry
|
#1 |
|
New Member
Join Date: Jun 2024
Posts: 1
Rep Power: 0  |
I have this geometry (attached in the image). I want to use ICEM to generate a hexa mesh with inflation layers. I have calculated the Y+ values and such.
I am a beginner to ICEM and I am not sure how to do the blocking around the complex geometry sections, especially around the tail/fins. I have seen videos on youtube, but they are all for simple geometry like 2D pipes or airfoils. Can someone help me with this? It would be nice if I could get some guidance. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] FOAM Warnings leading to no geometry, yet OpenFOAM says meshing finished w/o error | edomalley1 | OpenFOAM Meshing & Mesh Conversion | 2 | October 28, 2024 03:21 |
| [ICEM] Meshing a fractal geometry in ICEM | andrewmichael | ANSYS Meshing & Geometry | 0 | May 22, 2018 21:17 |
| Dynamic Meshing of Simple 2D Geometry | harman79 | FLUENT | 2 | January 17, 2018 07:07 |
| Gambit meshing problem to following geometry | ahmadmln | ANSYS Meshing & Geometry | 2 | October 21, 2014 02:49 |
| [ANSYS Meshing] Using more than one meshing method on a single 2D geometry | robbierich90 | ANSYS Meshing & Geometry | 0 | October 30, 2011 14:12 |
Linear Mode
