|
[Sponsors] |
May 26, 2024, 07:17 |
mashing Defrent Parts
|
#1 |
New Member
Ran soffer
Join Date: May 2024
Posts: 3
Rep Power: 2 |
I created a structure in SpaceCliam, and I want to save space, so I want to create inle and outlets with as little as much mash.... therefore, I created a few separate past-to-crate structure mash that reduces in density.... my problem is that fluent crate walls in between those parts but those parts are interior what I do?
|
|
Tags |
mash |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Structural Dynamic Analysis to Find the Response of Individual parts in an Assembly d | SaiPrasad Chowdavaram | Structural Mechanics | 0 | July 21, 2022 07:21 |
[ICEM] How to create multiple parts properly in ICEM-CFD? | ElGrande | ANSYS Meshing & Geometry | 0 | March 4, 2021 02:43 |
Generate Parts Using Named Selection | jonasohlsson | ANSYS | 1 | March 14, 2016 04:32 |
How to handle suction and pressure side of an airfoil as two different parts? | TKE | ANSYS Meshing & Geometry | 4 | March 17, 2011 06:49 |
[snappyHexMesh] SnappyHexMesh complex geometries amp thin wall parts | hsieh | OpenFOAM Meshing & Mesh Conversion | 0 | September 22, 2008 17:34 |