[ANSYS Meshing] Using inflation option to creat boundary layers -- CFD Online Discussion Forums

April 23, 2024, 05:19	Using inflation option to creat boundary layers	#1
tjwldhks79 New Member eddy Join Date: Jan 2024 Posts: 24 Rep Power: 2	I'm simulating the shape of an underwater robot. Before using the inflation feature, the mesh quality was good. However, due to the boundary layer creation, I have to use inflation, which causes the aspect ratio to become much larger than desired. How can I adjust this? I would appreciate any ideas or suggestions. Thanks

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
reverse flow in centrifugal fan blades	kalm	CFX	20	December 2, 2023 07:25
Table bounds warnings at: END OF TIME STEP	CFXer	CFX	4	July 17, 2020 00:44
Overflow Error in Multiphase Modelling with Two Continuous Fluids	ashtonJ	CFX	6	August 11, 2014 15:32
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05

All times are GMT -4. The time now is 23:18.