 |
 |
 |
|
|
|
[Sponsors] | ||||
March 4, 2024, 17:30
|
Meshing of cylindrical column in ICEM
|
#1 |
|
New Member
Join Date: Nov 2023
Posts: 7
Rep Power: 3  |
Hi there,
I am trying to make a cylindrical mesh with three circular inlets at the bottom, using ICEM (see attached picture). My problem is that some of the blocks at the edges get some cells that are very squished (circled in red). I was wondering if anyone know how to go about avoiding/improving these blocks? Any help would be really appreciated! |
|
|
|
|
|
March 12, 2024, 08:13
|
|
#2 |
|
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,913
Rep Power: 28 |
You have to create an O-Grid. Look for this in the help.
|
|
|
|
|
|
|
April 6, 2024, 09:10
|
|
#3 |
|
New Member
Join Date: Nov 2023
Posts: 7
Rep Power: 3 |
Thank you for your reply! I do not, however, understand how I would create an O-grid for the 'overall mesh', when I have to include the three spargers. Any suggestions on how to do this would be much appreciated!
Also, I created a grid that can be seen in the attachments. I am not quite happy with it. Ideas/suggestions for further improvements of this mesh would also be much appreciated! 
|
|
|
|
|
|
 |
| Tags |
| icem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing of rectangular bubble column | SphericalCube | Mesh Generation & Pre-Processing | 0 | November 22, 2023 07:50 |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
| Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 11:28 |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 05:25 |
| [ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 11:09 |
Linear Mode
