 |
 |
 |
|
|
|
[Sponsors] | ||||
January 30, 2024, 14:20
|
Flow promoter meshing
|
#1 |
|
New Member
Join Date: Dec 2019
Posts: 17
Rep Power: 6  |
Hello everyone ,
I have been trying to learn meshing lately and while doing so , I came across a problem in my research. This is a microchannel with some flow promoters that I have been trying to mesh. So far I have tried to apply multizone meshing and edge sizing. I also tried to use inflation without multizone , however the quality of the mesh decreases badly . I was wondering if I am missing something here. I have been unable to mesh in either of the methods used. Note the top wall is a plane wall and no vortex generators have been used there |
|
|
|
|
 |
| Tags |
| mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Match Pressure Inlet/Outlet Boundary Condition Mass Flow Rate | MSchneid | Fluent UDF and Scheme Programming | 3 | February 23, 2019 07:00 |
| [ANSYS Meshing] how to fix meshing fail due to sweep mode controls on simple multiphase flow sim | oberstar | ANSYS Meshing & Geometry | 1 | September 28, 2017 09:34 |
| [ANSYS Meshing] Suggestions needed for meshing axial flow pump with thin tip gap | jason580315 | ANSYS Meshing & Geometry | 0 | October 23, 2016 22:35 |
| [ICEM] ICEM Blocking and Meshing - Flow over Periodic Hill | Crank-Shaft | ANSYS Meshing & Geometry | 8 | April 29, 2014 04:11 |
| [ICEM] Multizone meshing Problem for External Flow Meshing | Hybrid | ANSYS Meshing & Geometry | 9 | March 29, 2013 10:24 |
Linear Mode
