[ANSYS Meshing] Unique undersired results appearing in Meshing

pranay10 · July 5, 2023, 07:08

I am using ansys meshing to mesh a 2d sinusoidal geometry. I have already done it many times on this geometry but however, ansys now decides to give some unique error.
I am sharing the google drive link wherein a desired mesh and an outcome mesh is displayed. Also, the geometry is attached that marks geometry is free from issue.

Gert-Jan · July 6, 2023, 08:56

Don't use external links. I won't open them!

Use this quide line on how to post images on this forum.
https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

pranay10 · July 6, 2023, 09:17

Thank You for the suggestion. I edited it. Kindly help.

Gert-Jan · July 6, 2023, 09:24

Difficult to say.
In my experience, ANSYS mesher prefers a number of small surfaces above a single large surface. Especially when it is a spline and build up of a lot or curves, possibly like yours. Difficult to judge from these images. In any case, better chop it into smaller pieces.
As an example. I never use surfaces of 360° when I try to mesh a cilinder. Then I always use 2 surfaces of 180°. Then the mesher has additional line to start meshing or to attached elements to. That often help.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 11:49
[ANSYS Meshing] Icem meshing queries	Mfaizan	ANSYS Meshing & Geometry	21	July 31, 2015 00:10
Meshing software comparison	Wikie	Mesh Generation & Pre-Processing	5	September 29, 2014 07:09
is free meshing or mapped meshing is best for flow problems	shanu	Main CFD Forum	0	February 18, 2010 12:58
[Other] is free meshing or mapped meshing is best for flow problems	shanu	OpenFOAM Meshing & Mesh Conversion	0	February 18, 2010 12:56

July 6, 2023, 08:56		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,928 Rep Power: 28	Don't use external links. I won't open them! Use this quide line on how to post images on this forum. https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

July 6, 2023, 09:17		#3
pranay10 New Member Prayan Join Date: Jun 2023 Posts: 10 Rep Power: 3	Thank You for the suggestion. I edited it. Kindly help.

July 6, 2023, 09:24		#4
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,928 Rep Power: 28	Difficult to say. In my experience, ANSYS mesher prefers a number of small surfaces above a single large surface. Especially when it is a spline and build up of a lot or curves, possibly like yours. Difficult to judge from these images. In any case, better chop it into smaller pieces. As an example. I never use surfaces of 360° when I try to mesh a cilinder. Then I always use 2 surfaces of 180°. Then the mesher has additional line to start meshing or to attached elements to. That often help.