|
[Sponsors] |
[ANSYS Meshing] Reducing element size increases turbulent |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Nopparuj Jongserechoke
Join Date: Nov 2022
Posts: 4
Rep Power: 3 ![]() |
I am trying to mesh the centrifugal blood pump model, where the smallest gap is 1mm, hence, I try to create a meshing element size of 0.25mm instead. But reducing elements size leads to a significant increase in turbulent viscosity during calculation.
I try using inflation and multizone, but multizone ended up with an error "multizone mesh bodies with multi shells to all hex is not supported" May I have any suggestions or methods on how to properly mesh this model? [IMG]file:///C:/Users/MBComputer/Downloads/model.png[/IMG] |
|
![]() |
![]() |
![]() |
Tags |
centrifugal blood pump |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] ParaView command in Foam-extend-4.1 | mitu_94 | ParaView | 0 | March 4, 2021 13:46 |
Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 06:00 |
Identifying Markers in a CGNS Mesh | tjim | SU2 | 3 | October 12, 2018 01:21 |
How to confirm mesh element size at turbo grid? | YOUNS | CFX | 2 | April 25, 2018 09:27 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |