|
[Sponsors] |
[ANSYS Meshing] Meshing multipart body without interior parts/surfaces |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Nikolaos Beratlis
Join Date: Jan 2010
Posts: 16
Rep Power: 16 ![]() |
I am trying to mesh a cube domain around a sphere with multizone method. I read in the STEP file into the DesignModeler and it consists of 6 parts as shown below
![]() I select all parts and form a new part. I then load it into the Mesh and create the Multizone mesh. Here is a section view ![]() When I read it into Setup I get a bunch of interior parts/surfaces. One the interior parts is shown in green color below ![]() Is it possible to create a geometry and mesh without any interior parts? What would be the correct way of doing it? |
|
![]() |
![]() |
![]() |
Tags |
interior parts |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Meshing solid body with pipes | woodwax | ANSYS Meshing & Geometry | 1 | March 10, 2021 17:41 |
Solid Body in Fluent Meshing Mode | yanki | FLUENT | 0 | October 12, 2018 07:56 |
[ANSYS Meshing] Body of influence substracts from part in Ansys Meshing | wimblo | ANSYS Meshing & Geometry | 0 | May 2, 2018 09:00 |
URGENT!!Need help my body dissapear in fluent after meshing | mizi | FLUENT | 4 | April 28, 2012 12:37 |
Meshing of Ahmed body | Farhat | FLUENT | 0 | May 27, 2007 00:08 |