 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] watertight geometry meshing HEX |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 25, 2021, 16:07
|
watertight geometry meshing HEX
|
#1 |
|
Member
Join Date: Apr 2020
Posts: 76
Rep Power: 6  |
Hello
I am trying to mesh an urban geometry model (watertight), similar to this: https://www.researchgate.net/publica...s/figures?lo=1 However, for whatever reason, the mesh is not as perfect as in the literature. There are some TET cells created and some anomalies. I have seen videos on Multizone, Sweep and so forth, but I can't get it to be perfect. Does anyone have a similar model to share? I would be grateful to check the mesh setting and see where I am wrong. Regards |
|
|
|
|
|
| Tags |
| canyon, hex dominant, multizone meshing, watertight |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] FATAL ERROR: face 6 in patch 2 does not have neighbour cell face: 4(8 9 21 20) | robingilbert | OpenFOAM Meshing & Mesh Conversion | 28 | November 23, 2023 07:32 |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
| [blockMesh] Problem with meshing complex geometry | Kelda | OpenFOAM Meshing & Mesh Conversion | 4 | April 16, 2020 10:21 |
| [blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 6 | June 19, 2017 15:12 |
| [blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 0 | April 7, 2011 12:09 |
Linear Mode
