[ANSYS Meshing] Unable to create hex mesh on a wing in ICEM

Roh4 · November 2, 2021, 13:55

Hello guys, iam trying to create a Hex mesh for my 3d wing which has an inverse zimmerman planform in ICEM, i hace created a C shaped domain.
I created the blocks, split it, associated the edges, gave node spacing and did everything, its getting meshed everywhere except on the wing surface.
Please help me out with this guys, its kinda urgent. I have attached the images below for the referrence.
Thanks.

mluckyw · November 9, 2021, 04:06

Have you do the face to selected surface associations? that might resolve the problems.

side note:
I hope that you are using a blunt trailing edge for the wing, as the mesh beside the wing tip will be compressed to oblivion if you use sharp TE.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face	A.A.	OpenFOAM Meshing & Mesh Conversion	41	June 26, 2020 08:06
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell	Arman_N	OpenFOAM Meshing & Mesh Conversion	1	May 20, 2019 18:16
[Other] mergeMatchPairs with arcs	vainilreb	OpenFOAM Meshing & Mesh Conversion	1	August 5, 2013 09:11
How to create a mesh use ICEM in CFX?	little stone	CFX	3	July 17, 2012 20:33
CheckMeshbs errors	ivanyao	OpenFOAM Running, Solving & CFD	2	March 11, 2009 03:34

November 9, 2021, 04:06		#2
mluckyw Member Chrowale Join Date: Sep 2021 Location: Bandung, Indonesia Posts: 63 Rep Power: 5	Have you do the face to selected surface associations? that might resolve the problems. side note: I hope that you are using a blunt trailing edge for the wing, as the mesh beside the wing tip will be compressed to oblivion if you use sharp TE.