 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Extra edges error in Spaceclaim |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 17, 2021, 10:29
|
Extra edges error in Spaceclaim
|
#1 |
|
New Member
Simranjeet Kaur
Join Date: Jul 2021
Posts: 4
Rep Power: 5  |
Hi there,
I'm trying to mesh a furnace as below and I have small inlets comprising of fuel, primary air and secondary air. When I use the Repair function, it keeps showing me to remove these inlets as they are classified as Extra Edges. Also, these Extra Edges act as free bodies in meshing later on. Is there any way for me to 'tell' Space claim that these aren't extra edges and I would require them without being free bodies? |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 10:12 |
| [snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 14:05 |
| SimpleFoam & Theater | jipai | OpenFOAM Running, Solving & CFD | 3 | June 18, 2019 11:11 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 18:16 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 04:21 |
Linear Mode
