[ICEM] Why there is a layer of blocks similar with a face between the two blocks

lbj007 · June 20, 2021, 09:20

maybe I split more than one time at the same point when I split the block?
how can i fix it, it's just too waste of time to start over again

alainislas · June 21, 2021, 16:03

Can you post a picture of your blocking? Also what exactly did you do? Check if you can re-start your case with one of the previous .blk files. They are labeled as 1, 2, 3, ... each time you save the project.

lbj007 · June 24, 2021, 00:22

Quote:

Originally Posted by alainislas

Can you post a picture of your blocking? Also what exactly did you do? Check if you can re-start your case with one of the previous .blk files. They are labeled as 1, 2, 3, ... each time you save the project.

now I delete it and restart to block,it doesn't show again

maybe I mishandled some process which I didn't realize, thank you anyway.

June 20, 2021, 09:20	Why there is a layer of blocks similar with a face between the two blocks	#1
lbj007 Senior Member Join Date: Feb 2020 Posts: 114 Rep Power: 6	maybe I split more than one time at the same point when I split the block? how can i fix it, it's just too waste of time to start over again

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
y+ = 1 boundary layer mesh with snappyHexMesh	Arzed23	OpenFOAM Running, Solving & CFD	6	November 23, 2022 16:15
[snappyHexMesh] No generation of layer onto zerothickness surface	crubio.abujas	OpenFOAM Meshing & Mesh Conversion	3	October 25, 2022 04:20
[snappyHexMesh] Invalid Normals for source face to target face while making AMI?	Sorabh	OpenFOAM Meshing & Mesh Conversion	1	August 3, 2021 07:35
GMSH 4.5.2: Prism Layer creation (3D boundary layer on 2D face))	ThomasEnzinger	Main CFD Forum	3	February 21, 2020 05:43
[mesh manipulation] createpatch not working when using layer addition in snappyHexMesh	Dikkeunit	OpenFOAM Meshing & Mesh Conversion	0	February 3, 2020 10:46

June 21, 2021, 16:03		#2
alainislas Senior Member Alain Islas Join Date: Nov 2019 Location: Mexico Posts: 142 Rep Power: 7	Can you post a picture of your blocking? Also what exactly did you do? Check if you can re-start your case with one of the previous .blk files. They are labeled as 1, 2, 3, ... each time you save the project.