[ANSYS Meshing] ICEM default stretching

vauntedmango · April 3, 2021, 08:36

Hello,

I am having an issue regarding ICEM meshing. I am trying to mesh this far field boundary (images attached), but without the geometric stretching. I have applied the stretching to one end of the edge, but although I have 0m spacing on the side '1', it shows that there is some stretching. Any ideas?

aero_head · April 3, 2021, 11:51

That's what the BiGeometric mesh law does. If you want to get rid of that and make it uniform, use the Uniform Mesh Law. If you want to increase the density of nodes on only one side, you need to use Geometric 1 or 2.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Workbench] ICEM failing to update mesh in a Workbench flow project	VladCFD	ANSYS Meshing & Geometry	7	July 2, 2020 03:53
[ICEM] Cannot update new.3dm file in ICEM based on rpl file	jimmy871013	ANSYS Meshing & Geometry	3	June 20, 2017 12:02
Cannot update new.3dm file in ICEM based on rpl file	jimmy871013	Mesh Generation & Pre-Processing	1	June 20, 2017 03:21
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 04:39
ICEM CFD 5.1 Hex-Tet mesh merging failure	bogesz	CFX	1	January 29, 2005 07:46

April 3, 2021, 11:51		#2
aero_head Senior Member Kira Join Date: Nov 2020 Location: Canada Posts: 435 Rep Power: 9	That's what the BiGeometric mesh law does. If you want to get rid of that and make it uniform, use the Uniform Mesh Law. If you want to increase the density of nodes on only one side, you need to use Geometric 1 or 2.