 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] How to change a box to an irregular polyhedron |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 21, 2020, 08:36
|
How to change a box to an irregular polyhedron
|
#1 |
|
Senior Member
Join Date: Feb 2020
Posts: 114
Rep Power: 6  |
I want to change the box to a polyhedron who's cross section of xz is Trapezoid. I wonder if there is some tricks to fix the lower edge,and just move the upper edge to make the length of edges along the x axis not the same。
|
|
|
|
|
|
| Tags |
| scdm |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] change/increase model size box | oewnce932c | ANSYS Meshing & Geometry | 5 | April 8, 2022 02:37 |
| How can I change Theta? | Terbulent | CFX | 1 | May 14, 2020 15:00 |
| Fluent doesn't interact with box? | jppilot | FLUENT | 5 | March 30, 2016 11:48 |
| no enthalpy change across the momentum source | Atit Koonsrisuk | CFX | 2 | December 19, 2005 03:33 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
Linear Mode
