|
[Sponsors] |
[ICEM] Is there any way to keep previous meshing in ICEM when I back to the ICEM from wbrenc |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: May 2020
Posts: 1
Rep Power: 0 ![]() |
Dear experts,
I have problems as followings, please help me. When I came back to ICEM CFD from Workbrench mechanical via interactive command which shown in attached file, previous meshing geometry changed automatically. It makes me that I have to do meshing steps again as before as I did. I think it is really time consuming. How can I update my meshing in ICEM without creating new one again? I want to update meshing of the geometry in ICEM and come back into workbrench mechanical. Best regards UNUR Last edited by Togtokhbuyan Munkhunur; May 6, 2020 at 10:49. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[ICEM] ANSYS Meshing & ICEM with one license | vasava | ANSYS Meshing & Geometry | 0 | March 20, 2015 08:13 |
[ICEM] ICEM Blocking and Meshing - Flow over Periodic Hill | Crank-Shaft | ANSYS Meshing & Geometry | 8 | April 29, 2014 03:11 |
[ICEM] problem with meshing in icem cfd | saurabhjoshi2011 | ANSYS Meshing & Geometry | 13 | March 12, 2013 11:27 |
[ICEM] 2d Aerofoil meshing in ansys ICEM | syler3321 | ANSYS Meshing & Geometry | 2 | February 3, 2012 01:59 |