|
[Sponsors] |
[ANSYS Meshing] ICEM Meshing - Wishbone Vortex Generator (BEGINNER) |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Josh
Join Date: Feb 2020
Posts: 3
Rep Power: 6 ![]() |
Hi,
Im trying to apply an ICEM mesh to a wishbone shaped vortex generator used for aerodynamic drag reduction on vehicles. Having no experience I have read through multiple tutorials and watched online videos but have established no clear cut method on how to set up a mesh for my specific geometry. I believe my issue is not fully understanding what associations need to be made between the split fluid blocking and lines/edges of the geometry as I have been trying many variations of splitting with edge association and deleting unnecessary blocks. For my geometry what is the best approach to take for associations? i.e. edge, point or surface. Any help and guidance would be greatly appreciated. Thanks in advance, Josh. |
|
![]() |
![]() |
![]() |
Tags |
aerodynamic, ansys, icem mesh, meshing, vortex generator |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Icem meshing queries | Mfaizan | ANSYS Meshing & Geometry | 21 | July 30, 2015 23:10 |
[ICEM] ICEM meshing - Tips from forum - Collection | shereez234 | ANSYS Meshing & Geometry | 0 | June 16, 2015 09:47 |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
[ICEM] problem with meshing in icem cfd | saurabhjoshi2011 | ANSYS Meshing & Geometry | 13 | March 12, 2013 11:27 |
ICEM Meshing | Jaloha | CFX | 0 | April 1, 2008 06:24 |