 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Fluent meshing: intentional voids removed |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 15, 2019, 09:49
|
Fluent meshing: intentional voids removed
|
#1 |
|
New Member
Sean Petley
Join Date: Oct 2014
Location: Lancaster, UK
Posts: 8
Rep Power: 12  |
I was recommended to use the new watertight workflow meshing available in Fluent Meshing.
I imported my model from DesignModeler, which has intentional void regions representing the turbine blades, however following the steps through Fluent Meshing removes these void regions when creating the surface mesh and the blades disappears from the boundary list, Has anyone else had similar experience and knows how to solve this? Thanks, Sean |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 10:07 |
| CFD simulation of gas cicrcuit breaker in fluent with dynamic meshing. | Mahesh7238 | FLUENT | 1 | April 5, 2021 01:21 |
| Fluent Meshing | sandyy235 | FLUENT | 3 | November 20, 2017 16:53 |
| FLUENT MESHING: Run in slurm code? | luiscssz | FLUENT | 0 | March 20, 2017 09:08 |
| Transfer named selections from SW to Fluent Meshing | the-sted | FLUENT | 0 | May 2, 2016 00:44 |
Linear Mode
