Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

ICEM CFD and Fluent

Updated Threads

Reply

Search this Thread

April 16, 2019, 08:35	single edge ICEM	#1
rainst New Member FengPengyu Join Date: Apr 2019 Posts: 1 Rep Power: 0	Hello everybody, Recently, I completed the grid division of proton exchange membrane fuel cells in ICEM CFD. single edge and uncovered face problems occurred during grid inspection. after the uncovered face problem was automatically fixed, separating wall and removing unreferenced faces appeared after the grid was imported into Fluent. thank you all, rainst. Last edited by rainst; April 18, 2019 at 22:11.

Reply

Tags

separating wall, single edge, unreferenced face

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[TurboGrid] turbogrid to icem cfd then icem cfd to fluent	tmeysam92	ANSYS Meshing & Geometry	0	May 7, 2014 07:25
Export mesh from ICEM CFD for Fluent	summerdream	ANSYS	2	September 10, 2013 13:12
Transport mesh from ICEM CFD, to Fluent, to Sysnoise	Wieland	FLUENT	2	April 15, 2012 07:28
Dimension conflict between icem cfd and fluent	highhopes	ANSYS Meshing & Geometry	1	September 9, 2011 12:07
[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent	ivanddd	ANSYS Meshing & Geometry	1	February 3, 2011 01:51

All times are GMT -4. The time now is 01:13.