 |
 |
 |
|
|
|
[Sponsors] | ||||
November 9, 2018, 12:17
|
Overlap mesh
|
#1 |
|
New Member
gabriel falcão dos santos
Join Date: Sep 2018
Posts: 1
Rep Power: 0  |
Dears,
I'm doing a ball valve simulation of a control valve. I'm having a problem with a overlap geometry. I had to divide the geometry in many parts to mesh with multizone method. With this the pos processor is having a problem to picture results. For exemple the next image: How can I solve this ? |
|
|
|
|
 |
| Tags |
| mesh, overlap, pos, processor |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ = 1 boundary layer mesh with snappyHexMesh | Arzed23 | OpenFOAM Running, Solving & CFD | 6 | November 23, 2022 16:15 |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| [ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 06:03 |
| [snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 17:59 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
Linear Mode
