 |
 |
 |
|
|
|
[Sponsors] | ||||
October 23, 2018, 11:08
|
ICEM local blocking
|
#1 |
|
New Member
Join Date: Oct 2018
Posts: 1
Rep Power: 0  |
Dear all,
I am new to using ICEM. I have trouble with the blocking approach. If I want to split a block, I want to split it only locally. However then I usually end up with terrible edge divisions as the split edges do not propogate throughout my domain. Does anybody has any experience with this? Thanks in advance. Kind regards, EngiPhys |
|
|
|
|
 |
| Tags |
| blocking, hexa meshing, icem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| p_rgh initial residual no change with different settings | manuc | OpenFOAM Running, Solving & CFD | 3 | June 26, 2018 16:53 |
| Help for the small implementation in turbulence model | shipman | OpenFOAM Programming & Development | 25 | March 19, 2014 11:08 |
| [ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator | Crank-Shaft | ANSYS Meshing & Geometry | 10 | March 23, 2013 22:24 |
| [ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 18:27 |
| [ICEM] Using Blocking with ICEM (infinity lines appear) | Touré | ANSYS Meshing & Geometry | 6 | August 5, 2012 18:07 |
Linear Mode
