[ICEM] cannot set boundary after split STL surface -- CFD Online Discussion Forums

June 11, 2018, 01:33

cannot set boundary after split STL surface

guohf

New Member

Join Date: Feb 2017

Posts: 5

Rep Power: 9

Hi, everyone,

I am a ICEM new user. I want to mesh a STL file with a tube. Following the help (Tetra/Prism Mesh Generation for an Aorta), split the surface by angle, however the angle value is only 10-15. How to determine the angle value?

I cannot select surfaces to define the boundary conditions. Why?

Please help me. Thanks very much

Attached Images

	1.jpg (54.6 KB, 1 views)
	2.jpg (60.8 KB, 1 views)
	3.jpg (78.6 KB, 1 views)

Last edited by guohf; June 11, 2018 at 04:46.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 07:20
[snappyHexMesh] Layers don't fully surround surface	EVBUCF	OpenFOAM Meshing & Mesh Conversion	14	August 20, 2012 05:31
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55

All times are GMT -4. The time now is 00:16.