[ICEM] How to mesh this geometry like a semi-sphere with high quality?

Yikun · May 6, 2018, 23:12

Hi, everyone.

I am working on meshing a geometry like a semi-sphere with ICEM. I tried a lot but the quality（especially the orthogonality） was not good. How to create blocks to get a good mesh?

I used swept blocks to make the orthogonality better. The value of orthogonality in fluent has increased to 0.48.

Thanks.

Best regards.

Gnak · May 8, 2018, 18:52

I remember there is a nice tutorial that goes through something similar to your problem, just look up icem tutorial online

Gnak · May 8, 2018, 18:53

Here's the link
https://docobook.com/ansys-icem-cfd-...ssouri-st.html

May 8, 2018, 18:52	Possible Solution	#2
Gnak New Member Nam Join Date: Jan 2018 Location: Canada Posts: 11 Rep Power: 8	I remember there is a nice tutorial that goes through something similar to your problem, just look up icem tutorial online

May 8, 2018, 18:53	Possible Solution	#3
Gnak New Member Nam Join Date: Jan 2018 Location: Canada Posts: 11 Rep Power: 8	Here's the link https://docobook.com/ansys-icem-cfd-...ssouri-st.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh - geometry does not appear in Mesh	czhongrong	OpenFOAM Meshing & Mesh Conversion	1	January 20, 2016 06:26
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 11:58
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38
unstructured vs. structured grids	Frank Muldoon	Main CFD Forum	1	January 5, 1999 11:09