[DesignModeler] Concept menu in ANSYS 18.0

S_998 · February 6, 2018, 12:11

Hello

I have currently upgraded to ANSYS 18.0
I have been looking for the concept menu option in geometry for the past hour. Can anyone tell me how to do lines from sketches in this version of ANSYS?

Far · February 6, 2018, 13:01

I can see the concept menu in ansys 18.1!!!

rahjou · December 21, 2018, 15:44

Quote:

Originally Posted by Far

I can see the concept menu in ansys 18.1!!!

You can or you can't?
Because there is no menu with "Concept" name in Ansys 18.1!

Mohammed_D · December 21, 2018, 17:05

Dear All,

I would like to mesh I 3D pool (Parallelepiped) I inject pure steam through a quencher containing 192 pores (square pore). the pose size is 100 micrometer.

I found problems in meshing this geometry, because of the pore size, it is too small. the pore area is (10e-9 m2) ... the pool surface area is 0,555 m2 ..

See the huge difference... I mean the smallest mesh size should the pore's... I still got error in meshing this geometry...

Any suggestion, recommendation is more than welcome, thank you in advance!!!

February 6, 2018, 12:11	Concept menu in ANSYS 18.0	#1
S_998 New Member sssss Join Date: Feb 2018 Posts: 1 Rep Power: 0	Hello I have currently upgraded to ANSYS 18.0 I have been looking for the concept menu option in geometry for the past hour. Can anyone tell me how to do lines from sketches in this version of ANSYS?

December 21, 2018, 17:05	Mesh using Fluent meshing	#4
Mohammed_D New Member Mustapha Mukhtar Join Date: Dec 2018 Posts: 7 Rep Power: 8	Dear All, I would like to mesh I 3D pool (Parallelepiped) I inject pure steam through a quencher containing 192 pores (square pore). the pose size is 100 micrometer. I found problems in meshing this geometry, because of the pore size, it is too small. the pore area is (10e-9 m2) ... the pool surface area is 0,555 m2 .. See the huge difference... I mean the smallest mesh size should the pore's... I still got error in meshing this geometry... Any suggestion, recommendation is more than welcome, thank you in advance!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Running Ansys in BAtch Mode	kuleuvenstudent	ANSYS	1	October 18, 2017 13:11
[ANSYS Meshing] ANSYS mesh - I was surprised...	assafwei	ANSYS Meshing & Geometry	0	September 4, 2014 13:17
Ansys HPC licensing policy	assafwei	ANSYS	0	June 29, 2014 17:00
How to model concrete slab in ANSYS and apply 2 million cyclic load.	jjc	ANSYS	3	April 12, 2011 05:47
Plant Menu	Scott	Phoenics	2	October 6, 2006 05:51

February 6, 2018, 13:01		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	I can see the concept menu in ansys 18.1!!!