 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] How to define a 'prism' wall when using unstructured mesh for an artery geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 1, 2017, 12:40
|
How to define a 'prism' wall when using unstructured mesh for an artery geometry
|
#1 |
|
New Member
Dominic Taylor
Join Date: Nov 2017
Posts: 1
Rep Power: 0  |
I have imported an stl file of a coronary artery and I need to mesh it for use in Fluent. When following the steps in the tutorial manual the mesh gives me tris at the wall and tetras in the centre. I am looking for a way to edit the mesh so that a clear prism wall layer is defined. Or at least the edges of the unstructured mesh are refined near the wall.
Thanks |
|
|
|
|
|
| Tags |
| ansys, icem, meshing, wall refinement |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Can I define periodic boundaries in an unstructured mesh? | Aoki | ANSYS Meshing & Geometry | 11 | September 14, 2018 02:52 |
| [snappyHexMesh] snappyHexMesh - geometry does not appear in Mesh | czhongrong | OpenFOAM Meshing & Mesh Conversion | 1 | January 20, 2016 06:26 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
| [ICEM] Why Icem can't craeate Unstructured 2d Mesh on Circular Geometry | Jvb | ANSYS Meshing & Geometry | 6 | January 2, 2012 12:41 |
| unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 11:09 |
Linear Mode
