[DesignModeler] Coordinate File Import ANSYS v18 Student

jcancino · October 21, 2017, 15:27

I am doing some tutorials for ansys but the version shown in the tutorial is v15 and I am using v18. Most of the time I can figure out the new layout but for the life of me I cannot figure out how to import a coordinate file in v18. There is no concept tab I can click on to get to 3D curve. I am trying to use a .txt file. Any help would be appreciated. It uses Space Claim.

sultzan · October 28, 2017, 09:35

Not sure how to create 3D curve from coordinate file in Space Claim - tried that and failed. However you can still use Design Modeler instead of Space Claim - just right click on the geometry in project schematic and choose Design Modeler.

I hope that solves the problem

October 28, 2017, 09:35		#2
sultzan New Member Join Date: Oct 2017 Posts: 20 Rep Power: 9	Not sure how to create 3D curve from coordinate file in Space Claim - tried that and failed. However you can still use Design Modeler instead of Space Claim - just right click on the geometry in project schematic and choose Design Modeler. I hope that solves the problem Last edited by sultzan; October 28, 2017 at 11:11.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[foam-extend.org] Problems installing foam-extend-4.0 on openSUSE 42.2 and Ubuntu 16.04	ordinary	OpenFOAM Installation	19	September 3, 2019 19:13
[OpenFOAM.org] Patches to compile OpenFOAM 2.2 on Mac OS X	gschaider	OpenFOAM Installation	136	October 10, 2017 18:25
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0	towanda	OpenFOAM Community Contributions	6	September 5, 2015 22:03
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch	gschaider	OpenFOAM Installation	225	August 25, 2015 20:43
[swak4Foam] Error bulding swak4Foam	sfigato	OpenFOAM Community Contributions	18	August 22, 2013 13:41