[ANSYS Meshing] Generating Sector Mesh using ANSYS FORTE -- CFD Online Discussion Forums

September 16, 2017, 15:13

Generating Sector Mesh using ANSYS FORTE

Avilash

New Member

Avilash Jain

Join Date: Sep 2017

Posts: 7

Rep Power: 9

Hello,

I have been trying for some days to generate 360/7 sector mesh in ANSYS FORTE for IC Engine combustion simulation. The bowl profile I have is hemispherical, but there is no direct topology available for a hemispherical bowl, so I have been trying Topology 1. I am doing closed cycle simulation using the generated mesh, but it is failing near TDC(-1.96 CA) and the reason of error specified is 'Inversion of cell at -1.96 CA'.

I am attaching related images.

Thank You very much.

Attached Images

	2.PNG (62.4 KB, 35 views)
	15.PNG (20.0 KB, 29 views)

Tags

ansys forte, hemisperical, mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Command Line Run for ANSYS	Liaquat	ANSYS	11	April 19, 2018 10:49
[ANSYS Meshing] Can start ANSYS meshing only one time on ubuntu 16.04	Touré	ANSYS Meshing & Geometry	2	September 26, 2017 06:41
A CFX-POST error (ver 14.5.7)	wangyflp88	CFX	2	July 22, 2017 01:17
ANSYS 13 Multifield,	mechanicaldesign	CFX	2	May 26, 2012 10:32
Ansys workbench problem	Jonny6001	ANSYS	2	September 30, 2010 13:59

All times are GMT -4. The time now is 10:45.