|
[Sponsors] |
[Workbench] how to create sub domain from a mold part in ansys |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 10, 2017, 16:58 |
how to create sub domain from a mold part in ansys
|
#1 |
New Member
Join Date: Sep 2017
Posts: 2
Rep Power: 0 |
good afternoon to all, i need help to solve the below problem which is a part of my project.
i am working with ansys polyflow- blow molding. for calculating the pure mass of the material which is blown in the cavity, ansys says that i need to define a sub domain which shows just inside the cavity, not other parts of the cavity. how can i define a sub domain for a specific part of a cavity in ansys? hope to be helped, thanks all. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] how to create sub domain in ansys | babaee_m | ANSYS Meshing & Geometry | 0 | September 10, 2017 10:04 |
[ICEM] How can I create prism mesh for a 3D domain surrounded by a torus? | lzgwhy | ANSYS Meshing & Geometry | 5 | May 18, 2017 17:10 |
Ansys SIG$ILL error | loth | ANSYS | 3 | December 24, 2015 05:31 |
Structural analysis- bosy surface part from the solid part | andreina | Structural Mechanics | 0 | October 12, 2015 09:56 |
ANSYS CFX/Mechanical - fluid domain error | amsys | CFX | 1 | September 15, 2015 11:12 |