[ANSYS Meshing] open a complicated geometry generated from SpaceClaim by using Ansys meshing

zeng1017 · June 23, 2017, 18:26

Hi everyone,
I have generated a complicated geometry from SpaceClaim. It has 371 components (picture 1). When I was trying to open it by using Ansys meshing, it takes forever to open. The Ansys meshing has been in this status for a whole day (picture 2).

Is there any way to solve this problem?

Any help appreciated.

vasava · July 3, 2017, 06:55

If the file size is big it will obviously take long time to load. Have you tried with smaller number of components?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam for OpenFOAM 4.0	mnikku	OpenFOAM Community Contributions	80	May 17, 2022 09:06
Meshing 2D sharp geometry with ICEM or Ansys mesher	Ulixes	ANSYS Meshing & Geometry	0	May 16, 2017 11:10
Problem compiling a custom Lagrangian library	brbbhatti	OpenFOAM Programming & Development	2	July 7, 2014 12:32
"parabolicVelocity" in OpenFoam 2.1.0 ?	sawyer86	OpenFOAM Running, Solving & CFD	21	February 7, 2012 12:44
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 06:22

July 3, 2017, 06:55		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	If the file size is big it will obviously take long time to load. Have you tried with smaller number of components?