 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2017, 09:06
|
Names of parts
|
#1 |
|
New Member
Codemania34@yahoo.com
Join Date: May 2017
Posts: 13
Rep Power: 9  |
I have named some parts of the geometry in Ansys in the mesh part. But when I displayed them there were more parts. Five name is given by me but I cannot understand how other two came? İnterior_surface_body, wall_surface_body.
Thank you. |
|
|
|
|
|
June 18, 2017, 21:26
|
|
#2 |
|
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
you have not defined(named) whole geometry, so Ansys did it for you.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Extrude 2D mesh, face names to volume names, line names to face names | baloe | ANSYS Meshing & Geometry | 0 | January 6, 2017 18:39 |
| Generate Parts Using Named Selection | jonasohlsson | ANSYS | 1 | March 14, 2016 05:32 |
| [snappyHexMesh] Multi region meshing & recovering the original patch names | fluidpath | OpenFOAM Meshing & Mesh Conversion | 4 | May 19, 2013 20:13 |
| [snappyHexMesh] SnappyHexMesh complex geometries amp thin wall parts | hsieh | OpenFOAM Meshing & Mesh Conversion | 0 | September 22, 2008 18:34 |
| ICEM Hexa - Deleting Empty Parts!! | James Date | CFX | 4 | December 23, 2004 02:24 |
Linear Mode
